Online Support Centre

Getting started - Voyager 205

1. Before installing your Voyager 205 Router, it is imperative that:

  • Your telephone line has been configured for broadband and has been activated.
  • You have your Broadband Username and Password.
  • If you are replacing an existing broadband modem, it must be unplugged from your line and uninstalled from your computer.
  • Your computer meets the minimum specification required.

2. Please ensure that you have the following items in the Voyager 205 box:

  • One Voyager 205 Router
  • Two broadband microfilters
  • One grey Ethernet Cable (RJ-45)
  • One black Broadband Line Cable (RJ-11)
  • One blue USB cable
  • One power supply
  • Installation CD
  • Foldout Quick Start Guide

3. Plug a microfilter into every telephone socket that has telephony equipment attached to it (e.g. phone, fax, answering machine, caller ID, cordless base, skybox)

Connect your existing telephony equipment to the Phone socket of the microfilter.

4. To install the Voyager 205:

  • Locate the Voyager 205 near a phone socket on your broadband line
  • Plug the Power Supply and the black Broadband Line Cord into the sockets on the back of the Voyager 205 (sockets are marked Power and DSL respectively)
  • Plug the Power Supply into the nearest mains socket and make sure the socket is switched-on
  • Plug the Broadband Line Cord into the DSL socket of the Broadband Microfilter
  • Plug the microfilter into a telephone socket on your activated broadband line
  • Press the power switch on the back of the Voyager 205. The Power light on the front will turn green.
  • Wait until the DSL light on the front stops flashing and is solid green.

5. If the DSL light is OFF or keeps flashing, please check the following:

  • Your Broadband Line Cord is connected at one end to the DSL socket of a microfilter and at the other end to the DSL socket in the back of your Voyager 205.
  • There are no other broadband modems or routers connected to the line.
  • You are using the Broadband Line Cord supplied with your Voyager 205.
  • If you are replacing an existing broadband modem or router on your broadband line, you might have to wait several minutes for the network to detect your new router. Leave the Voyager 205 connected to the line and switched-on. After a while, the DSL light should be permanently solid green.
  • Try using another microfilter.
  • Disconnect every other telephony device from your line. If this solves the problem, reconnect them one by one to try and isolate the device that is causing the problem. Try using a different microfilter for this device.
  • If none of the above works, please contact us.

Please note that the Ethernet and USB may be used simultaneously to share your Internet connection, however presently there are NO compatible USB drivers for Windows Vista.

 


Has this page helped you solve your problem? Your feedback helps us to improve the help we provide.

Rate this page : happy neutral unhappy

Please note: We cannot reply to individual feedback through Rate My Page. If you need more help with a problem please use Contact Us.


Installing the Voyager 205 - USB connection

Internet security - Voyager 205

Installing the Voyager 205 - Ethernet connection

Service Status RSS icon

Broadband OK
Email OK
Webspace & FTP OK
Newsgroups OK
Support services OK
My Account OK
  • Informational : General Information
  • Maintenance : Planned Maintenance

Customer Care: 0844 395 0830 or 0345 140 0200 (7 days a week, 365 days a year)
Technical Support: 0844 395 0830 or 0345 140 0200 (7 days a week, 365 days a year)
Calls to our 0844 support number cost 6p per minute plus your phone company's access charge.
Copyright ©Madasafish